The CRAZEDpiot Digital Dimmer Controller is designed to provide smooth brightness control for LED lighting using pulse technology to prevent heat generation and current draw commonly found in inferior designs. Can drive up to a 5 AMP total load at 12 volts! That's over 15ft of LED lighting! Includes black panel-mount knob, signal potentiometer, and detailed installation instructions with clear wiring diagram. Weighs ONLY 2 ounces installed! The controller is driven from your 12 VDC battery.
Includes potentiometer and knob for adjusting the brightness output of the CRAZEDpilot Dimmer Controller remotely from your panel - just connect the potentiometer to the controller using three wires and you're set!
Have a 24 volt system? No problem! 24V aircraft can utilize our own 12 volt stepdown transformer CLICK HERE TO ORDER IT TOO! If you have any questions, don't be afraid to ask by using the Contact us page! Thank you for your purchase!
INSTALLATION DIAGRAM AND INSTRUCTIONS PDF - CLICK HERE TO VIEW.
NOTE: For experimental aircraft only.
This product to be used for lighting controls only. As the pilot in command you are accepting all responsibility for the safety of your aircraft, those onboard, and persons or property on the ground. CRAZEDpilot makes no representations of warranties, either expressed or implied, by or concerning any content of these written materials and in no event shall be liable for any implied warranty for any consequential, incidental or indirect damages (including but not limited to damages for loss of business profits or business interruption) arising from the use or inability to use these written materials or equipment.
3 Reviews Hide Reviews Show Reviews
Their product support and technical support could not be any better. I highly recommend this product and Crazedpilot!,
Lights are very bright with 3cell battery.
Took about ten minutes to install the unit.